Stauf PUK 446 2K PU Parquet/Wood Glue light 9 kg (purchase per pallet 65st)
| Article number: | 13230 |
| EAN: | 8718074964372 |
- 2 to 7 days delivery time (possibly longer depending on plant)
- Laagste prijs tot wel 75% korting !
- Houtafwerkingsspecialisten sinds 1976
- Grootste voorraad van de Benelux (+1000m2)
- Reeds 200.000+ tevreden klanten
- Customer service from 10:00 to 18:00
Stauf PUK 446 2K PU Parquet/Wood Glue light 9 kg, (purchase per pallet 65st)
Shear-resistant 2K polyurethane parquet adhesive. Rapid strength development, long processing time. Shear-resistant elastic, therefore stress-reducing. Very low emission.
Special features
• long processing time
• very low emissions
• universally applicable
Permissible floor coverings
• Mosaic lamella on edge thickness according to DIN EN 14761
• Lamparquet according to EN 13227
• Solid plank floors
• Multi-layer parquet according to DIN EN 13489
• Mosaic parquet DIN EN 13488
• Solid parquet strips according to DIN EN 13226
Permitted substrates
• Mastic asphalt with sand sprinkled in
• Concrete C 25 / 30 according to DIN 1045 (rough surface)
• Calcium sulphate (anhydrite) cast floors
• STAUF parquet tiling agents
• Chipboards V100 (E1), OSB
• Cement screeds
Product Features
• without solvents
• not sensitive to frost
• very easy to spread
• rapid development of strength
• anhydrous
Instructions,
Apply the adhesive evenly with the appropriate notched trowel with prescribed serrations in a smooth motion, avoiding glue pools and excess thickness. Apply the parquet in the adhesive bed within the specified time with a short sliding movement and press the floorboard firmly. Particularly with unfinished parquet, care must be taken not to slide glue between the joints. Glue in the joints can react negatively with subsequent finishing products. Glue residues can be removed with the appropriate STAUF stain remover, depending on how hard they are. Assess the expected result in an inconspicuous place or on a leftover piece of factory-finished parquet. In the unfavorable case, eg after a long time, the removal of cured adhesive residues can only be done mechanically, whereby slight damage cannot be ruled out. So make sure to remove glue stains immediately, or even better, work with care so that they do not occur. After mixing, apply the adhesive within the specified open time.
