Wakol MS230 Polymer Parquet Glue content 18kg

Wakol MS 230 Polymer Parquet Glue content 18kg,

The parquet adhesive MS 230 is especially suitable for the full bonding of multi-layer parquet with a knife/groove connection. Based on the increasing need to glue multi-layer parquet, Lecol has developed a new glue that is especially suitable for this purpose.

Advantages,

application,
Elastic, 1-component parquet adhesive for the installation of:
high-edge parquet flooring according to DIN EN 14 761, at least 22 mm thick, maximum 200 mm long
strips of parquet (22 mm), wood type oak according to DIN EN 13 226
multi-layer parquet according to DIN EN 13 489
on absorbent and non-absorbent substrates indoors.

When applied with WAKOL Special glue spreader 5 also suitable as glue with an integrated moisture barrier. Only for parquet types with a tongue and groove connection on sand cement subfloors without underfloor heating with 4 CM % and 85 % corresponding relative humidity.

Technical data
Raw material base: Silane modified polymer
Waiting time: none
Application time: approx. 40 min.
Setting time: approx. 24 hours
Cleaning agent: WAKOL RT 5960 Cleaning cloths before the adhesive hardens
Shelf life: 18 months at room temperature
Storage temperature: not sensitive to frost

Take a look at shipping info for the exact shipping costs for more than 1 bucket of glue !! (these are not automatically calculated but will of course be added) !

--TECHNICAL INFORMATION--

subfloors,
The substrate as well as the climatic conditions must meet the requirements of the valid standards and data sheets. Subfloors must be permanently dry, form-retaining, flat, free of cracks, contaminants and substances that could impair the bond.
Calcium sulphate bonded floors according to the manufacturer's or supplier's instructions. mechanically pre-treat and vacuum in accordance with the applicable standards and information leaflets.
If the screed is dust-free, the parquet can be glued directly to the substrate. If a primer is necessary, WAKOL Primer can be used on cement and calcium-bound (anhydrite) screeds. On mastic asphalt screeds, only use Wakol reaction primers such as WAKOL PU 280 Polyurethane Primer.
The Wakol MS-Parquet adhesive can be used as a moisture barrier on sand cement screeds without underfloor heating up to 4 CM % or up to 90 % corresponding relative humidity.
In this case of application with WAKOL Special Glue Trowel 5, only the above-mentioned parquet types with tongue and groove joints may be installed.

Instructions,
Apply evenly to the substrate with the notched trowel, avoiding glue accumulations.
Insert the parquet immediately and press firmly. Make sure that the surface on the underside of the wood is sufficiently covered with glue.
Clean tools with cleaning cloths immediately after use. After drying, the glue can only be removed mechanically.